Product description Application instructions: 1. ) take out the decals carefully from the container. 2. ) place the decals on the table before applying and check the left and right sides properly. Ensure the sticker is in an appropriate position without any bubbles and overlapping also count the number of pieces. 3. ) clean the surface of your bike with distilled water (please do not use ground or any hard water) to make it free of all dust and grease and wipe with a clean dry cloth. 4. ) remove the paper from the bottom of the decals. Make sure you remove this gently. 5. ) moist the decals with water from the backside and paste them into the desired location. 6. ) when you are satisfied with the placement, apply the decals on the surface & squeeze water 7. ) set the decals on the surface and once you are satisfied with the placement, apply the decals on the surface of the bike. 8. ) gently remove the protection tape. Make sure the decal does not get stretched. Important instructions: 1. ) will not be accepted if the seal is broken. 2. ) professional installation is highly recommended for this product. 3. ) if there is moisture in the air then a heat air dryer is recommended on the surface of the vehicle (not on decals) to remove excess water from decals. 4. ) it is recommended to apply decals in sunlight. This will make the application easier. 5. ) wipe with isopropyl alcohol or another residue-free cleaner. Do not use toluene it may spoil metallic paint topcoats. 6. ) dry the surface with a clean, lint-free cloth before the cleaning solvent evaporates. 7. ) do not wash your Bike for minimum of 24 hrs after pasting.