A-One Winter Care Electric Blankets (Entirely Made in India)
- NEW SLEEPING CONCEPT a revolutionary way.
- Most Convenient and economical way of keeping a person warm
- Useful for Arthritics/Old Age Pains.
- LED Indicator for Clear Viewing.
- Even Distribution of Heat.
- Water Proof Element Teflon Coated for complete protection
- Complete insulated on either side for complete safety and comfort.
Our A-One Winter Care Electric Blankets were carefully designed to provide uniform and gentle warmth. It is a perfect night-time companion during intolerable cold winter nights. It will provide long term cost efficient comfort. This product is highly recommended for elders with old-age pains and people with aches and pains.
With temperature settings: Off/Low/High, On/Off (0-1-2-0).Sizes 30” x 60” and 60”x60”
Temp. Setting For Sizes 36”x60”, 45” x 60”, 36”x 72”, 72”x60” H -High, M - Medium, L -Low, On/Off.
SIZE | Power consumption per hour | SIZE | Power consumption per hour |
30” x 60” | 80 watt | 60” x 60” Dual Control | 150 watt |
36” x 60” | 90 watt | 72” x 60” Dual Control | 180 watt |
45” x 60” | 110 watt | 72” x 60” Automatic | 170 watt |
36” x 72” | 110 watt | 72” x 75” Automatic | 190 watt |
The products are exclusively designed for warming of the bed, taking 20-25 minutes to reach optimum temperature. They operate on 220-250 VAC, 50-60 Hz
Blankets/Mattresses/Pads carry a one year warranty.
- The warranty is valid if only the product has not been tampered with and all the instructions as mentioned above have been adhered to.
- The manufacturer, after inspection, will repair or replace the product or any component of the product found to be defective during the warranty period.
- The decision will be subject to the degree of problem and the judgment of Winter Care team.
- The replaced product will be a new piece.
- This is an exclusive warranty. This warranty is valid for the purchaser from the date of initial purchase and is not transferable.
- This warranty does not cover normal wear and tear of parts or damage resulting from negligent use or misuse of the product or use on improper voltage
- READ THE GUIDELINES CAREFULLY BEFORE USING YOUR ELECTRIC BLANKET
- The heated area of any warming bedding should always lie flat. That is, it should never be bunched up, folded or balled up (e.g. between the mattress and the footboard) such that the heat generated in the middle of that ball has no place to escape.
2. There should be nothing between the user's body and the heated bedding except a bed-sheet.
3. Turn off the bedding appliance when not in use.
4. Do not use two electric blankets together for one person.
5. Do not tug at the wires or use the cord as a handle.
6. Do not use warming bedding alone with infants or very small children, people with disabilities, anyone who is immobile or cannot operate the controls properly, anyone insensitive to heat or anyone who cannot understand these directions.
7. Do not allow pets to be around your warming bedding. A sharp claw or a tooth may puncture the wire insulation or damage the wiring itself.
- Do not use pins, nails around warming bedding. They can puncture the heater wire insulation.
- Never run the control cords between the mattress and the box springs. The cord could become damaged by friction or the heat from the electricity in the cord could be trapped there with no place to escape.
- Wrapping the cord around the controls may damage the cord. Loop loosely when storing.
11. Never iron your electric blanket. Ironing may damage the heating wire insulation.
12. Never dry clean or use cleaning fluid on your product. Dry cleaning agents contain solvents which may damage the heater wire insulation.
13. Don’t use an electric blanket on a waterbed.
14. If you observe your electric blanket operating unusually or improperly (e.g. seems too hot in one area or you see a scorch mark) contact the manufacturer.
15. Do not use with damaged cords.
16. Keep the control away from drafty areas that may become damp or wet such as an open window.
17. Be sure this blanket/mattress pad is used on 200-230 VAC supply.
18. Don’t reconnect the heated product or use it until it is COMPLETELY dry.
19. Do not use another electronic heating device in conjunction with your heated product or else both of them may get damaged.
20. Do not use controller cable as a handle of the blanket.
Helpline no: 9250027671 Visit us at - www.shantinathsales.com
THE FOLD TEST
The blanket, if spread out, may not feel hot just when it is touched due to the heat escaping in the open air. To test if it is working properly, the following test may be conducted:
- Fold the product 3-4 times.
- Connect the blanket to an electric outlet and turn it on.
3 Switch the controller to the highest temperature and wait for 4-5 minutes.
4 Put your hand between the folds of the blanket and you will be able to feel the blanket grow hot.
5 If the problem persists, contact the seller.
6
CAUTION: Do not conduct this test for more than 10 minutes for the safety of product.Aone Winter Care
)
)
)
)
)
)
Change Model
Remove
