Instruction for use: 1. It can be placed on any smooth clean and dry surface like shelf, board, wood cabinet,drawer,walls,window,glass almirah and so on. It is applied at room temperature. 2. Sand down rough surfaces prior to sticking. Clean large surfaces with mild soap and water. 3. Measure the surface to cover. Cut the film into right size, leaving about 5cm extra overlap on all edges is better 4 peel nearly 1 inch of back paper from vinyl .not to let adhesive side touch anything. 5 determine the placement, apply the skin(Sticker) to the surface using your fingers or the side of your thumb or soft cloth starting from one corner and working your way across the surface. 6 if a piece is not going on straight, you can gently lift it and replace 7 creases and air bubbles can be removed by applying light pressure from the center to the edges with the help of plastic card or cloth pierce stubborn bubbles with a needle and squeeze the air out. Optional: 1 apply hot air to the decal surface to activate chemical agent for better stickiness. Using a hair dryer is fine. 2 you can apply water and soap solution to waterproof surfaces before application. This will temporarily lessen stickiness of vinyl thus can be applied easily. After application remove excess moisture stickiness will be back after few hours when it dries this multi-purpose contact paper can protect the furniture from humidity and dirt efficiently. A adorable furniture accessories for your daily home life. Material: pvc.