Prithvi Concrete Vibrator is an important mechanical component in modern construction engineering. Because of the small size and easy operation, it is widely used when pouring concrete requires internal compaction of concrete specimens and a good alternative to traditional tamping bar, especially when there are large numbers of specimens to be compacted. Fantastic results during pouring concrete columns, walls, primary, secondary beams and precast. Heavy Duty 1200W Copper Motor maintains high standard efficiency during usage. RICH FEATURES: 1. Easy Movement, 2. Stable Operation, 3. Good Mechanical Performance, 4. Low Noise, 5. Super Power, 6. Beautiful Look, 7. Light Weight. HEAVY DUTY COPPER MOTOR - How to use: (1) Adhesive and flat vibrator bearings shall not be subjected to axial forces. The motor shaft shall be kept horizontal when in use. (2) When multiple attached vibrators are used simultaneously on one template, the frequencies of the vibrators should be consistent, and the vibrators on the opposite side should be staggered. (3) Before the operation, the attached vibrator should be inspected and tested, and the test vibration should not be carried out on dry hard soil or hard objects. The vibrator installed on the silo of the mixing station shall be equipped with a rubber mat. (4) When installing, the position of the screw hole of the vibrator bottom plate should be correct. The mounting of the foot bolt should be prevented from being skewed and the casing should be damaged. The anchor bolts should be fastened and the tightening degree of each bolt should be the same. (5) When using, the cable should not be pulled too tightly, and should not be broken. When working, always observe the leakage protector of the electrical equipment and the grounding or zeroing device and confirm the pass. (6) When the attached vibrator is installed on the concrete framework, the vibration time should not exceed 1 min. When the concrete flows in the mold or flows horizontally, the vibration can be stopped, and the concrete should not be re-energized in the initial setting state of the concrete. (7) The component template of the device vibrator should be firm and reliable, and its area should be compatible with the rated vibration area of the vibrator. (8) When the flat vibrator is working, the flat plate should be kept in contact with the concrete so that the vibration wave can effectively vibrate the concrete. When the surface is paddle-free, it can move slowly forward without sinking. The moving speed should be able to Ensure that the concrete is tapped out. The vibrating vibrator shall not be placed on concrete that has been condensed or initially solidified. 1.5m Long HEAVY DUTY NEEDLE: a. Powerful Concrete Vibrator: 1200W Motor, b. Voltage: 220 V, c. Vibrator shaft Diameter: 35MM, d. Vibrator shaft Length 1.5m, e. Vibrator shaft Lightweight and compact design for all day use, f. Vibrator shaft Efficiency Concrete Vibrator - 5000 rpm, g. Ergonomically Design Lock-on button for extended use, it can reduce your work pressure, h. Vibrator shaft If vibrator cannot work, please knock the vibrating bar on the ground several times, then it will work. Because the vibrator is working when you put the power on, but the vibrating bar does not get the same frequency with the vibrator. After the vibrating bar knocks the hard stuff, it will have the same frequency with the vibrator to work well.